Products

AudioJoG^(TM) Pro Operations Manual

METHOD 1 - Manual Double Ended
This is the preferred method for testing a cable that is different to the previously tested one and has both ends available for plugging into the AudioJoG^(TM) Pro.

1. Plug one end of the cable to be tested into an appropriate socket using the 'Local' half of the tester.

2. Plug the other end of the cable into an appropriate connector using the 'Remote' half of the tester.

3. Switch ON.
After a brief random display, ALL the LED's should turn ON for a couple of seconds and then turn OFF. If this is not the case then please check the power and mains connections, otherwise return the AudioJoG^(TM) Pro for repair.

4. To start the test press and release the TEST button. On the lower row of LED's the No1 LED will turn ON,

A single LED ON indicates that there are no connections to that pin (Fig1).

Two or more LED's ON (either row) indicate the connection from PIN 1 of the connector plugged into the local half to the remote half of the tester (Fig2).

5. Press and release the TEST button again, the current LED's will go out.

If there were no connections in previous step then the upper LED No1 will turn ON (Fig3).

Or if there were connections in the previous step then the local No2 LED will turn ON (Fig4).

As before if there are any other LED's ON (either row) then they indicate the connection from the PIN 2 of the connector plugged into the local half of the tester.

Repeat step 5 until the local or both SCREEN LED turn ON (Fig5).

This is the end point for the visual test procedure, AudioJoG^(TM) Pro can not decide for you whether the results are correct or not.

Then either:-
Press and release the TEST button to clear the display
and take you back to step 4. Or see next chapter for how to automatically test cables against details held in memory.

Introduction

METHOD 2 - Automatic Double Ended

METHOD 3 - Manual Single Ended

METHOD 4 - Automatic Single Ended

LED/Connector pin identification table