Products

AudioJoG^(TM) Pro Operations Manual

METHOD 4 - Automatic Single Ended
This uses two AudioJoG^(TM) cable testers. As with the process of going from Manual to Automatic Double ended testing the start of the Automatic testing is the completion of the Manual test ending on the 'local' screen LED.

1. Once again at the 'local' screen LED on position press and hold until the MEMORY LED lights (Fig13).

2. After a few seconds (if there are unconnected pins then this will increase the test time) the display should show the Pass (green) and MEMORY (Yellow) LED's. If the Fail LED is on then there is probably an intermittant connection in the cable.

3. Plug in the cable to be tested using the same connector(s) and locations as before.

4. Press and release the TEST button.If all is well the Pass LED will turn ON, remove the cable. To test another cable repeat steps 3 & 4.

5. To clear the MEMORY either, switch OFF and then ON again or, press and hold the test button until the MEMORY LED goes OFF.

6. If the FAILED LED turns ON, then the AudioJoG^(TM) Pro has found a difference between the cable details in memory and the current cable. The numbered and screen LED's will stop at the error stage. Examples of failures follow:-

a) A short was found, on the lower connector, where no connection existed before (Fig14).

b) An open connection was found, usually indicated by a single LED (Fig15).

c) A short to SCREEN, this may be indicated by one, or both the screen LED's being ON in conjunction with another pair of LED's (Fig16).

7. Press the TEST button to proceed, if there are more failures the test will stop at each and everyone of them, finally only the FAILED and MEMORY LED's will be ON.To test another cable repeat steps 3 & 4. To clear the MEMORY option either, switch OFF and then ON again or, press and hold the test button until the MEMORY LED goes OFF.

Introduction

METHOD 1 - Manual Double Ended

METHOD 2 - Automatic Double Ended

METHOD 3 - Manual Single Ended

LED/Connector pin identification table